Advertisement

Gas Powered Grass Trimmer
model numbers 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218
IMPORTANT:
Instruction
Read and follow all safety rules and operating
Manual
instructions before using this product.
RS25CCPR
115791532 Rev. B 2015-12-19
RS25CSPR

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 060-2343-8 and is the answer not in the manual?

Questions and answers

Summary of Contents for Yardworks 060-2343-8

  • Page 1 Gas Powered Grass Trimmer model numbers 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 IMPORTANT: Instruction Read and follow all safety rules and operating Manual instructions before using this product. RS25CCPR 115791532 Rev. B 2015-12-19 RS25CSPR...
  • Page 2 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 This unit can be dangerous! Careless or Watch out for thrown objects and ricochets. improper use can cause serious injury. Read the instruction manual before use. Failure to follow the instructions could result in serious injury to the operator and/or bystanders.
  • Page 3 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 a WARNING: Never use blades with the attachment) below waist level and away from all parts of your body. Keep all parts of your body away from the This unit (when it is used with the supplied line trimmer attachment) is attachment).
  • Page 4 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 Use a container approved for fuel. by law that many internal combustion engines be equipped with a spark arresting Do not smoke or allow smoking near fuel screen. If you operate in a locale where or the unit.
  • Page 5 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 a WARNING: The blade continues to ADDITIONAL SAFETY RULES FOR OPTIONAL ATTACHMENTS spin after the trigger is released or a WARNING: For each optional attachment used, read the entire Stop the blade by contacting the left...
  • Page 6 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 a WARNING: Make sure the locking/ CAUTION: If received assembled, repeat all steps to ensure that your unit is release button is locked in the properly assembled and all fasteners are...
  • Page 7 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 ADJUSTING THE HANDLE 1. Loosen the wing nut on the handle. be sure it remains above the safety label 2. Rotate the handle on the shaft to an and below the mark or arrow on the upright position;...
  • Page 8 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 BEFORE STARTING THE ENGINE a WARNING: Be sure to read the fuel information in the safety rules before the safety rules, do not attempt to fuel HOW TO START YOUR UNIT...
  • Page 9 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 STARTING A WARM ENGINE 1. Move the start lever to the RUN position. 2. Squeeze and hold the throttle trigger. Keep the throttle trigger fully squeezed until the engine runs smoothly. Pull the starter rope sharply while squeezing the throttle trigger until the engine runs.
  • Page 10 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 a WARNING: Make sure the locking/ a WARNING: Always wear eye release button is locked in the primary hole and the knob is securely ricochet or be thrown into eyes and...
  • Page 11 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 or asphalt can cause excessive wear to the wire. trimmer head. If the line is worn down to 2 For mowing or sweeping, use full throttle inches (5 cm) or less, more than one tap will for a good, clean job.
  • Page 12 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 SWEEPING — The fanning action of the rotating line can be used to blow away loose debris from an area. Keep the line parallel to and above the area surface and swing the tool from side to side.
  • Page 13 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 a WARNING: Never use wire, rope, INSPECT THE MUFFLER AND SPARK ARRESTING SCREEN 5. When installing new line on an existing contains chemicals known to the spool, hold the spool as shown in the illustration below.
  • Page 14 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 the replacement trimmer head onto the shaft by turning it. Tighten until secure. Turn the trimmer head clockwise to install it. 5. Remove the screwdriver. ADJUST THE IDLE SPEED a WARNING: Keep others away when...
  • Page 15 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 a WARNING: Recheck the idle speed time: Clean the entire unit before lengthy head, blade or optional attachment storage. must not move or spin at idle speed Store in a clean dry area.
  • Page 16 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 a WARNING: Always stop the unit and disconnect the spark plug before performing all of the recommended remedies below except remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not start.
  • Page 17 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 STATEMENT IMPORTANT: This product is compliant with U.S. EPA Phase 3 regulations for exhaust and evaporative emissions. To ensure EPA Phase 3 compliance, we recommend using only genuine replacement parts. Use of non-compliant replacement parts is a violation of federal law.
  • Page 18 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218 approved HCOP servicing center. CONSEQUENTIAL DAMAGES: HCOP may be liable for damages to other engine components caused by the failure of a warranted part still under warranty. WHAT IS NOT COVERED: All failures caused by abuse, neglect, or improper maintenance are not covered.
  • Page 19 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218...

This manual is also suitable for:

060-2344-6

Table of Contents