Troubleshooting; General; Dab Reception - Yamaha CRX-330 Owner's Manual

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.

General

Problem
This unit fails to
The power cable is not connected or the plug is not
turn on or enters completely inserted.
the standby mode
This unit has been exposed to a strong external
soon after the
electric shock (such as lightning or strong static
power is turned on.
electricity).
No sound No appropriate input source has been selected.
Speaker connections are not secure.
The volume is turned down.
Signals this unit cannot reproduce are being input
from a source component, such as a CD-ROM.
Sound is heard Incorrect cable connections.
from the speaker
on one side only.
There is noise
This unit is too close to the digital or high-
interference from frequency equipment.
digital or radio
frequency
equipment.

DAB reception

Problem
Cannot tune into
The initial scan operations were not performed.
any DAB stations.
There is no DAB coverage in your area.
The DAB signals are too weak.
The initial scan
The DAB signals are too weak.
operations are not
successful and
There is no DAB coverage in your area.
"Not found"
appears on the
front panel display.
The DAB station The positioning of the indoor DAB/FM antenna
reception is weak.
and/or this unit is not optimal for DAB reception.
The DAB signals are too weak.

TROUBLESHOOTING

Cause
Connect the power cable firmly.
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and
then use it normally.
Select an appropriate input source with the INPUT
on the front panel (or the input selection keys on the
remote control).
Secure the connections.
Turn up the volume.
Play a source whose signals can be reproduced by
this unit.
Connect the cables properly. If the problem persists,
the cables may be defective.
Move this unit further away from such equipment.
Cause
Perform the initial scan operations
Check with your dealer or WorldDMB online at
http://www.worlddab.org for a listing of the DAB
coverage in your area.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna.
Check with your dealer or WorldDMB online at
http://www.worlddab.org for a listing of the DAB
coverage in your area.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna and this
unit for optimal DAB reception
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna.
Remedy
Remedy
See
page
11
—
—
9
—
—
9
—
See
page
22
—
23
23
—
23
23
29
En