Attaching The Stand; Specifications - Yamaha NS-U30 Owner's Manual

ATTACHING THE STAND

Attach the included stands to the speakers using two
screws each. By attaching the stands, the speakers
can be used at an appropriate angle, with the front of
the speakers slanting slightly upward. Be sure to
attach the stands to the speakers correctly as shown
in the figure. If you attach them incorrectly or in the
opposite direction, the speakers may fall and be
damaged or cause personal injury.
* Nonskid pad
* Nonskid pad
To prevent the speakers from sliding, attach the
supplied pads as shown in the figure.
You can also use the screw holes on the rear of
the speakers to install them.
60 mm
2
E-
* @
*
*
A screw with a diameter of 4 mm
and a pitch of 0.7 mm can be
used. (Depth of hole: 8 mm)

SPECIFICATIONS

Type ...... 2-way acoustic-suspension speaker system
Driver
Woofer ................................ 9 cm (3-1/2") cone type
Tweeter ................................. 2 cm (3/4") dome type
Nominal input power ........................................ 20 W
Maximum input power ..................................... 60 W
Sensitivity ........................................................ 88 dB
Impedance .......................................................... 6 Ω
Frequency response ........................ 75 Hz – 25 kHz
Dimensions (W X H X D)
.................................. 110 mm
(4-3/8" 11-1/2"
Weight ..................... 1.8 kg (4.0 lbs., stand included)
Accessories .............................................. Stand
Speaker cord [2 m (6.6 feet)]
* Specifications are subject to change without notice.
Magnetically shielded type
293 mm 192 mm
7-1/2", stand included)
Nonskid pad
Screws
2
2
8
4