Ucare Cam App Overview; Ios – Setup Ucare Cam Wifi; Use Wps (Wifi Protected Setup); Wifi Setting Or Wifi Connect Tab - Konig SEC-IPCAM100B Manual

C. uCare Cam APP Overview
Default camera password:
Default manager name:
Default manager password:
There are 4 major function tabs at the bottom of the App main screen.
Camera List Tab
This is the main App screen. In this tab, all of the cameras which have been added
will be listed.

WiFi Setting or WiFi Connect Tab

Please go to this tab to configure the uCare Cam WiFi settings.
There are two methods to install a new uCare Cam and connect it to a WiFi
Router.
1. Router Mode
2. WPS (WiFi Protect Setup) Mode
(Requires a Router with WPS function using WPA/WPA2 encryption -
WEP encryption will not work)
Play List Tab
Go to this tab to view all pictures taken by the user via smartphone. The pictures will be listed by camera.
Settings Tab
Configure uCare Cam settings and remote microSD Card video playback.
User will need to input a management ID and password to enter this tab.
Default management ID: admin Default password: 0000
If you forget your password, you can reset the uCare Cam by pressing the WPS/REST button on the back of
the camera for 10 seconds. This will restore the uCare Cam to factory settings. You will need to set up the
WiFi connection again after you reset the camera.
D. iOS – Setup uCare Cam WiFi
Method 1: Use WPS (WiFi Protected Setup)
Available if your WiFi router supports WPS and it is set to use WPA or WPA2 security encryption. WEP
security encryption is not supported in WPS mode. An easy way to check if your router supports WPS is to
look for a button that says "WPS" on the router. It may also be called "AOSS" or "QSS".
1. Press and hold the WPS/REST button for 10 seconds at the back of the camera. It will reset and restart
the uCare Cam. After about 60 seconds, the LED colour should
2. Press "WPS" button on the WiFi router
3. Press the WPS/REST button on the back of the uCare Cam for 2 seconds.
If the uCare Cam has entered the WPS connection mode,
•
blinking green.
4. The uCare Cam will try for up to 2 minutes to connect to the WiFi router using WPS.
5. If the LED colour changes to
LED does not change to orange, the setup has failed. Please make sure the uCare Cam is within WiFi
distance of your router, press the WPS/REST button for 10 seconds to reset the uCare Cam, and try the
setup again.
6. Use the smartphone App to add the uCare Cam into the Camera List. See instruction manual – "iOS - Add
uCare Cam (already connected to router) to App".
0000
admin
0000
orange, your uCare Cam has successfully connected to your router. If the
6
flash green and red.
the status LED colour will turn a fast