Reversing The Door (Gvs04 Only) - GE GVS04 Owner's Manual And Installation

Reversing the Door.
Hinge
cover
Plug Button
Bottom
Hinge
Leveling Leg
10
(GVS04 Beverage and Wine Center Only)
Unplug the beverage and wine center.
Screw
Tape the door shut with masking tape to secure alignment.
Remove the top hinge cover by removing the screw.
Top
Hinge Remove the 2 screws securing the top hinge to the frame.
Lean the beverage center backward to access the bottom hinge.
Remove the 2 screws securing the bottom hinge assembly to the frame.
NOTE: If you lay the unit on its back, be sure to let it stand upright for at
least 2 hours before connecting to the power source; this will reduce the
possibility of a malfunction in the cooling system.
Remove the Plug Button from the top left side of the door.
Install the Plug Button into the hinge hole on the right side.
Press firmly to secure.
If the handle has been installed, remove it and install it
on the opposite side. Refer to Door Handle section for instructions.
Bottom
Hinge
Hold the door securely in place and install the bottom hinge on the
opposite side.
Install the top hinge and cover on the opposite side. Make sure the door is
aligned with the cabinet before tightening the screws.
Remove the tape. Open and close the door to check alignment with the
cabinet. If necessary, loosen the screws on the bottom hinge, realign the
door, and retighten the screws.
Plug in the beverage and wine center.
NOTE: If you had to lay the unit on its back, be sure to let it stand upright
for at least 2 hours before connecting it to the power source; this will
reduce the possibility of a malfunction in the cooling system.
Set the temperature controls to the desired setting.