Helpful Hints - Panasonic PT 56DLX76 Operating Instructions Manual

Remote Control Battery Installation
Requires two AA batteries (supplied).
1
. While pressing in on the catch, open cover in
direction of arrow.
2
. Install batteries in the battery compartment.
• Battery polarity (+) and (-) must match the markings
inside the compartment.
3
. Press cover until it snaps shut.
CAUTION
Incorrect battery installation can cause the batteries to
leak, leading to personal injury and/or damage to the
Remote Control.
Observe the following precautions:
1. Always replace batteries with a pair of new ones.
2. Do not combine a new battery with an old one.
3. Do not mix battery types (example: "Zinc Carbon"
with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries.
5. Battery replacement is necessary when the Remote
Control acts sporadically or stops operating the
Projection Display set.
Two AA size

Helpful Hints:

(1) Frequent Remote Control users, choose
long-lasting Alkaline batteries as replacements.
(2) Whenever batteries are removed, you may need
to reset Remote Control infrared codes.
We suggest making a note of the codes on page
70 prior to setting up the remote.
Emergency Alert System ( EAS)
Forced Tuning
If a CableCARD™ is installed, the cable MSO
(multiple system owner/operator) may provide an
Emergency Alert System message. These messages
are intended to alert the general public of important
local or national emergency situations. In the event
of receipt of one of these messages, the Projection
Display shall immediately tune to the channel as
directed by the EAS message. If the channel has
been blocked using the parental control, the parental
blocking has priority over the forced tune.
Reset All Memory Functions
Use when moving unit to a new location, or when First
Time Setup needs to be done over.
Press the VOL- button on the unit
and OK button on the Remote
Control at the same time for more
than 3 seconds. Unit shuts itself off
when reset is done.
• POWER indicator flashes red. After
flashing stops, unplug the unit then
plug it back in and turn power ON.
Note:
• When using "Control with HDMI (HDAVI Control)", with the
device connected, set "Ctrl with HDMI" first to "Off" and then
"On" using the Setup Menu. (p. 68)
7