Power On / Off; Auto Shut Off - Panasonic PT 52LCX66 Operating Instructions Manual

Multimedia projection hdtv
Table of Contents

Advertisement

Power ON / OFF

Turning the Power ON and OFF
Always be sure to follow the procedure given below to
turn the Projection Display power ON and OFF.
• The lamp cooling fan will continue to operate for
approximately 1 minute after the power is turned off. During
this time, the POWER indicator will blink Red.
Do not disconnect the power cord from the outlet
and do not open the circuit breaker (unless
necessary) while the cooling fan is still operating. Do
not disconnect the power cord from the power outlet
while the power indicator blinks Red.
24
For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at: http://www.panasonic.com/contactinfo
The Power Indicator
LED
Off
Red (blinking)
Green
Green (blinking) Power – ON (Preparing to light lamp)
Notes:
• If the POWER button is accidentally turned off during use,
• After the unit is turned on, maximum picture brightness will be
• This unit consumes approx. 0.4 W in OFF condition when
Press POWER on Projection Display or Remote Control
to turn power on.
The Power Indicator blinks Green for about 20 seconds
and then turns solid Green.
Press POWER on Projection Display or Remote Control
to turn power off.
Power shuts off after a Black Screen is displayed for a
few seconds.
Note:
• If the POWER button is pressed during the Black Screen
POWER button/
POWER indicator
The Power Indicator blinks Red for about 1 minute and
then LED turns off.
Note:
• When the power cord is disconnected, the internal cooling
ACTION
Power – OFF
Power – OFF (Now cooling)
Power – ON
after power is turned back on, it may take a short period
before the lamp automatically comes on.
achieved in 5-10 minutes. This is normal.
plugged into an AC outlet.
Power ON
Power OFF
display, Power is turned back on.
fan stops op er at ing. In this case, the lamp will be insufficiently
cooled and will take a while to turn ON again.

Auto shut off

To conserve lamp life, if there is no signal to the
set's tuner for 5 minutes, the lamp will shut off
automatically.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents