Completion Display; Data Display; Error Messages - SJ SwaLLow Operating Instructions Manual

9. Completion display

END 030:00 00000
NC 100mA 10.75V

10. Data display

INC
INPUT = 12.00V
OUTPUT = 13.18V
DEC
INC
DEC
If the Battery type button is pressed for over 3 seconds, the Data view will be displayed as above.
Data displays can be scrolled left and right by INC & DEC buttons.
If the Battery type button is again pressed, those data view screen should be disappeared.
This screen is only shown if a balancing connector is connected.
LCB-[01]= 0.000V
Press the ENTER button then the "01" should flash, each cell voltage is shown by INC & DEC
LCB-AVG = 0.000V
buttons.
This screen is also only shown if a balancing connector is connected.
LCB-MAX= 0.000V
Its shows each maximum and minimum voltages on the screen.
LCB-MIN = 0.000V

11. Error messages

INPUT BATTERY
VOLTAGE ERROR
NO BATTERY
OUTPUT BATTERY
REVERSE POLARITY
OUTPUT CIRCUIT
PROBLEM
CHECK THE BATT.
OPEN CIRCUIT
CHECK THE BATT.
OVER VOLTAGE
CHECK THE BATT.
LOW VOLTAGE
BALANCER VOLTAGE
IS TOO HIGH
BALANCER VOLTAGE
IS TOO LOW
DONT CHARGE LIXX
WITH THIS MODE
In order to move to the main display, press the Enter button.
INC
ChgCAPA=00000mAh CHG PEAK = 12.00V
DchCAPA=00000mAh DCHG AVR = 13.18V
DEC
INC
0.00 0.00 0.00V LCB-MAX = 0.000V
0.00 0.00 0.00V LCB-MIN = 0.000V
DEC
When input voltage is below 11.0V or exceeds 15V.
When a battery is not connected to the charger's output
When a battery is connected to the output in reverse
When the circuit of the charger has a problem
When a battery becomes disconnected during an operation
If wrong voltages are set while charging lithium or Pb batteries.
If wrong voltages are set, or batteries are over discharged, while charging Lithium or Pb
batteries
If voltage per cell is too high during balancing, this message should appear.
If battery cells are short-circuited during balancing, this message should appear.
If the charger starts charging, discharging, or cycle for NiCd/MH, or Pb batteries with
connecting the balancing cable to the balancing port of the charger.
INC
LCB-[01] = 0.000V
LCB-AVG = 0.000V
DEC
INC
DEC
11
Operating Instructions
ENTER INC
LCB-[02] = 0.000V
LCB-AVG = 0.000V
DEC