Ballu BSGI 12 Service Manual page 21

6 . C O N T R O L M O D E L
6 . C O N T R O L M O D E L
BSGI 09(12)
6-1. Major general technical parameters
6-1-1 Conditionings for operation: Ambient temperatures: (-15 - +45 ℃), relative humidity (45 -
85%).
6-1-2 Remote receiver distance: 8 m.
6-1-3 Remote receiver angle: Less than 80 degrees.
6-1-4 Temperature control accuracy: ±1℃.
6-1-5 Time error: Less than 1%.
6-1-6 The power supply for the air conditioner is a.c 220V, 50Hz, with its fluctuation in the
range of (198～264V).
6-2. Functions of the controller
6-2-1 Display panel
I. Control functions of the remote controller (See operating and installation manual)
II. Display of the indoor unit
Information on the screen:
The picture of the display is as follows:
Displaying Scheme:
Temperature display：Display set temperature or indoor temperature , and display fault code
in trouble indicating. An error code is displayed according to the signal from the indoor CPU.
The error code will flash for 5 seconds while displayed.
Running indicator：It is on during operation. It flashes in 10s after the sleep modehas been
setted.
TIMER indicator：When the timer mode works, the indicator will be lighted.
Sleep indicator：When the sleep mode works, the indicator will be lighted.
Compressor indicator：It lights up when compressor is running.
Remote control receiver： This section receives signals from the remote controller.
6-3. Control function
6-3-1 Emergency switch
6-3-1-1 Press the emergency switch once to turn on the machine and press it again to turn off
the machine; in the automatic mode, the indoor control temperature is set at 24℃ with the
indoor fan speed setting is automatic and the flaps sweep.
6-3-1-2 When the machine is turned on (in the OFF condition), press and hold the emergency
18