Audio Devices With Cable Connection; N-Com Rider-Passenger Intercom Mode; Intercom Affiliation; Intercom Function - N-Com multi 3 User Instructions

11. AUDIO DEVICES WITH CABLE CONNECTION

The N-Com systems can be connected through various "Multimedia Wire" to external audio devices:
MP3 players, Satellite navigators, GMRS and PMR radio and audio systems pre-fitted on motorcycles
(MCS).
To find out about all the available cables, please visit the website www.n-com.it in the "Cable connection
compatibility" section.
Connect the 3.5-mm 4-pole connector of the Multimedia wire to the helmet and the other end to the
audio device. A coloured band on the cable indicates the connector to be hooked up to the audio
device.
Once it is turned on, cable connection stays active even in the subsequent menus. Consequently, you can
hear the device connected via cable even while listening to music via A2DP or via RADIO.

12. N-COM RIDER-PASSENGER INTERCOM MODE

In order for two N-Com systems to communicate with one another, they have to be paired up first.
12.1.

Intercom affiliation

1. Make sure both N-Com Bluetooth systems are turned off;
2. Set both N-Com Bluetooth systems in Pairing up mode by pressing "on" (for more than 4 seconds),
until the LEDS start to flash quickly;
3. On either one of the two helmets, press "on" briefly;
4. After a few seconds, the helmets "recognize" each another, a beep is emitted to signal the pair up
was successful and intercom communication is activated;
5. Turn off both N-Com Bluetooth systems and turn them back on to store the pair up data.
12.2.

Intercom function

After carrying out the proper pair up procedure, turn on the two helmets. Intercom connection will be
established automatically (this will take a few seconds. Wait until you hear the vocal confirmation
message). If automatic connection is not possible, proceed with the manual connection.
Manual intercom activation
Manual intercom deactivation

13. N-COM BIKE-TO-BIKE INTERCOM

The N-Com system is used for bike-to-bike communication up to a distance of about 500 m (open
terrain, no obstacles).
N.B.: The range and quality of the communication may very significantly depending on the presence of
obstacles, weather conditions, magnetic fields.
N.B.: The range of the communication varies depending on the N-Com systems used.
The MULTI 3 system stores up to 4 different MULTI 3 systems, so that "calls" can be made to these
devices.
So that two MULTI 3 systems can communicate with one another in the Bike-to-Bike mode, they must be
paired up first.
With MULTI 3 turned on, briefly press "on".
With MULTI 3 turned on, briefly press "on".
MULTI 3
15