Oil Level Stick - Arctic Cat Prowler Operator's Manual

Display Fault Description
P0266 Cylinder #2 Fuel injector Balance/
Open
P0336 Crankshaft Angle Sensor Synchroni-
zation
P0337 Crankshaft Angle Sensor Circuit/SG
P0339 Crankshaft Angle Sensor Intermittent/
Erratic
P0340 Camshaft Angle Sensor Synchroniza-
tion
P0341 Camshaft Angle Sensor Circuit/SG
P0342 Camshaft Angle Sensor Intermittent/
Erratic
P0480 Fan-Primary/Right Relay Control Cir-
cuit
P0481 Fan-Secondary/Left Relay Control
Circuit High
P0482 Fan-Secondary/Left Relay Control
Circuit Low/SG/Open
P0483 Fan-Secondary/Left Relay Control
Circuit
P0484 Fan-Primary/Right Relay Control Cir-
cuit High
P0485 Fan-Primary/Right Relay Control Cir-
cuit Low/SG/Open
P0500 Vehicle Speed-Sensor
P0508 Idle Air Control System Circuit Low/
SG
P0509 Idle Air Control System Circuit High/
Open
P0520 Engine Oil Sensor/Switch
P0562 System Voltage Low
P0563 System Voltage High
P0601 ECM CAN Communication Shutdown
P0615 Starter Relay Circuit
P0616 Starter Relay Circuit Low
P0617 Starter Relay Circuit High
P0630 VIN Not Programmed or Incompatible
P0642 Sensor Power Circuit Low
P0643 Sensor Power Circuit High
P2300 Ignition Coil #1 Primary Circuit Low/
SG/Open
P2301 Ignition Coil #1 Primary Circuit High
P2303 Ignition Coil #2 Primary Circuit Low/
Open
P2304 Ignition Coil #2 Primary Circuit High
P2531 Ignition Switch Circuit Low
P2532 Ignition Switch Circuit High
FUEL Tilt Sensor Activation Code
OFF

Oil Level Stick

There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
32

NOTE: The vehicle should be on
level ground when checking the
engine oil level.
1. Remove the seats and center console
(Prowler) or lift the cargo box
(HDX).
2. Unscrew the oil level stick and wipe
it with a clean cloth.
3. Install the oil level stick.

NOTE: The oil level stick should be
threaded in for checking purposes.
4. Remove the oil level stick; the engine
oil level should be within the operat-
ing range.
CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
within the operating range but not
above the FULL mark.
5. On the 700 HDX to add oil, remove
the seat, oil fill cap, and oil fill plug.
After adding oil, install the fill plug
and tighten securely; then install the
cover and seat. On the 500 HDX/
Prowler models, add oil to the oil
level stick opening until proper oper-
ating level is achieved.
GZ461A
HDX234A