Troubleshooting - POLTI FOREVER 609 Instruction Manual

11. TROUBLESHOOTING

PROBLEM
If water comes out from
the Iron soleplate in-
stead of steam.
Steam does not come
out from the Iron sole-
plate
Little steam comes from
the Iron soleplate.
Some water drops are
present on the fabric.
Presence of water un-
der the appliance.
If problems persist or are not listed above, please contact a Polti Authorised Service Centre
(www.polti.com for the updated list) or contact Customer Services.
CAUSE
The pressure values have
not been reached
The temperature knob on
the iron is set at the mini-
mum value.
First steam release.
No power / On-Off swit-
ch is off
Water tank is empty.
The steam is dry, so is ba-
rely visible, but is present
and effective.
The cover used on the
Ironing board is wet since
it cannot withstand the
power of the steam sta-
tion.
Boiler cap not screwed
on properly.
Seal of boiler cap dama-
ged.
| 24 |
SOLUTION
Check that the ready steam lamp is
OFF indicating that the Vaporella
has reached the right pressure
Wait until the required temperature
and pressure are reached as shown
by the indicator lights.
Adjust the temperature knob on
the iron to the medium/maximum
vaue.
Release onto a cloth until steam
comes out from the holes on the
solepate.
Check that the power is on and
that the On/Off switch is pressed.
Fill the water tank.
This is normal especially in particu-
lar environmental conditions.
Check that the Ironing board is sui-
table (ironing board with grid that
prevents condensation).
Unscrew and rescrew the boiler
cap (Chapter 9).
Replace the damaged seal (Chap-
ter 9).