Configuring Lacp (802.3Ad) For Gigabit Interfaces - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring LACP (802.3ad) for Gigabit Interfaces

Configuration Examples
This example shows how to configure port-channel interface 1 to be inactive if fewer than 2 member ports
are active in the EtherChannel:
Device> enable
Device# configure terminal
Device(config)# interface port-channel 1
Device(config-if)# lacp min-bundle 2
Device(config-if)# end
Configuring LACP (802.3ad) for Gigabit Interfaces
Perform this task to create a port channel with two bundled ports. You can configure a maximum of four
bundled ports per port channel.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface port-channel number
4. ip address ip-address mask
5. exit
6. interface type slot/subslot/ port
7. no ip address
8. channel-group channel-group-number mode {active | passive}
9. exit
10. interface type slot/subslot/ port
11. no ip address
12. channel-group channel-group-number mode {active | passive}
13. end
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
360
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Configuring IEEE 802.3ad Link Bundling