Ip Address - Manual Configuration - Unify CP200 Administrator Documentation

administration.fm
Administration
IP Network Parameters
3.4.4

IP Address - Manual Configuration

If not provided by DHCP dynamically, you must specify the phone's IP address and subnet
mask manually.
IP addresses can be entered in the following formats:
>
– Decimal format. Example: 11.22.33.44 or 255.255.255.0 (no leading zeroes).
– Octal format. Example: 011.022.033.044 (leading zeroes must be used with every
address block)
– Hexadecimal format. Example: 0x11.0x22.0x33.0x44 (prefix 0x must be used with
every address block)
By default, IP configuration by DHCP and LLDP-MED is enabled. For manual IP configuration,
please proceed as follows:
Data required
• IP address: used for addressing the phone.
Subnet mask: subnet mask that is needed for the subnet in use.
•
Administration via WBM
1. Navigate to Network > General IP Configuration. Set DHCP Enabled, DHCPv6 Enabled
and LLDP-MED Enabled to "not selected". Afterwards, click Submit.
Network > General IP configuration
General IP configuration
IPv4_IPv6
Protocol Mode
LLDP-MED Enabled
DHCP Enabled
DHCPv6 Enabled
VLAN discovery LLDP-MED
VLAN ID
workgroup
DNS domain
Primary DNS 192.168.1.105
Secondary DNS
HTTP proxy
Submit
Reset
N
2. Navigate to Network > IPv4 configuration or IPv6 configuration, depending on the settings
in Protocol Mode IPv4/IPv6. Set DHCP Enabled , resp. DHCPv6 Enabled and LLDP-MED
Enabled to "not selected". Enter the IP address and the Subnet mask. If applicable, enter
the Default route. Afterwards, click Submit.
62
OpenScape Desk Phone CP200/400/600, Administrator Documentation
A31003-C1000-M101-1-76A9, 03/2016