Table of Contents
Advertisement
Installation of the AG-YA70
The AG-YA70 is an interface board that enables the AG-MX70 to be connected to a serial digital interface (SDI).
Follow the procedure below to install it.
<Note>
Always consult your dealer or authorized service center regarding installation of the AG-YA70 in the AG-MX70.
1)
Turn off the power of the AG-MX70, remove the ten
screws from the bottom panel, and detach the top
part including the LCD. Refrain from using any force
to pull the top part away from the bottom part since
the two parts are still connected by cables. (Refer to
the figure on page 101.)
2)
Remove the 20 screws, and remove the shield plate.
3)
Remove the six screws from the rear panel of the AG-
MX70, and remove the blank panel.
Screws for anchoring
the AG-YA70 board
Screws for
anchoring the
motherboard
6)
Refer to the figure on the right, and insert the AG-
YA70 board.
7)
Secure the two screws which were removed in step
4).
8)
Secure the six screws which were removed in step 3).
9)
Tighten up the five screws which were loosened in
step 5).
EXT IN
KEY
Y
Y/V
P /V5
B
Y/V
P /V7
B
L
4)
Remove the two screws anchoring the AG-YA70 on
the motherboard.
5)
Slightly loosen the five screws anchoring the
motherboard.
Screws for
anchoring
the AG-VE70
board
10)
Refer to the figure on the left, and plug the cable
attached to the AG-YA70 into the AG-MX70.
11)
Secure the screws which were removed in steps 2)
and 1).
100
P
P
B
R
VIDEO IN
P
YC
P /V6
P
Y/V
YC
R
B
R
1
2
P
YC
P /V8
P
Y/V
YC
R
B
R
3
4
AUDIO IN
L
L
R
R
R
1
2
Blank panel
MIC
V
Screws (a 6)
V
Hide quick links:
Advertisement
Table of Contents
