Upgrading Beltpack Firmware - ClearCom FreeSpeak II User Manual

 The master volume level for the beltpack can be set by using the beltpack
menu options. See Figure 8-1 B eltpack menu controls
 Configuring the beltpack volume settings.
 The incoming audio level can be adjusted during talk or listen on the
beltpack using the beltpack's rotary level controls.
To adjust the listen level during talk or listen from the beltpack:
 During talk and listen, use the rotary level control to increase or decrease
the incoming volume level ("listen level") for that assignment.
Note: You can also configure the incoming audio volume using the Configuration Editor
or the EHX software.
7.3.7

Upgrading beltpack firmware

Note: Before attempting an upgrade, ensure that all the antennas are connected.
Note: While the beltpack software is being upgraded, do not attempt to retrieve a Base
station configuration file or the upgrade may not successfully complete.
From the Configuration Editor, you can upgrade the beltpack firmware using a
USB connection or central upgrade Over The Air (OTA).
Note: If you have a matrix connection, you can also do an Over The Air upgrade. For
more information, see the Eclipse HX Configuration Software User Guide.
7.3.7.1 Upgrading using a USB connection.
1) Connect the beltpack to a USB port on the computer running the
Configuration Editor.
2) Select Diagnostics > Tools > Apply Wireless Firmware Via USB.
3) Browse to the location of the upgrade file (.FWS), and then select Update
Firmware.
The upgrade file is downloaded to the beltpack.
Note: You can connect more than one beltpack to the computer if you have multiple
USB ports. The units will be upgraded sequentially.
7.3.7.2 Upgrading by Over The Air Upgrade
1) From the Configuration Editor, Select Send File, and then browse to the
location of the upgrade file (.FWW).
2) Select Open. The download will begin. The beltpacks will be disconnected
while the download file is loaded onto the antennas.
Page 99
User Guide | FreeSpeak II™ Base station version