Name And Function Of Parts; Main Unit; Pen; Changing The Pen Battery - Pioneer pdk-50hw2a Operating Instructions Manual

NAME AND FUNCTION OF PARTS

<Main Unit>
Power switch
ON
Rear side
of unit
OFF
RS-232C DC IN
DC-IN jack
RS-232C
connector
<Pen>
Tip
Cap
Small button
(corresponds to middle
mouse button)
Pen tip
(corresponds to left mouse button)
<Changing the Pen Battery>
1 Rotate the battery cover to the left (counterclockwise),
and pull off to remove.
2 Insert a new AAA battery, aligning the +/– polarity
properly in accordance with the diagram (insert the "–"
end first against the spring, then slip the "+" side into the
tube slot).
3 Replace the battery cover and rotate to the right
(clockwise) to tighten.
4 Depress the small button fully to confirm that the LED
indicator lights.
NOTES:
÷ To prevent damage from battery leakage, remove the
battery when not using the pen for an extended period
(1 month or more). If battery leakage occurs, wipe away
any battery fluid from inside the case and replace the
battery with a new one.
÷ The provided alkaline battery should not be recharged,
short-circuited, disassembled, or disposed of in fire.
÷ When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country / area.
18
En
Power indicator
(Lights green when ON)
NOTE:
When the power switch is first turned on, the power
indicator will flash orange; while the indicator is flashing
(about 3 seconds), do not touch the screen, since the unit is
initializing its internal settings.
Battery cover hole
LED indicator
Battery cover
Large button
(corresponds to right
mouse button)

PEN

NORMAL
If pen operation becomes difficult:
The pen may fail to operate properly if the battery cover
holes are blocked. Also, the pen may begin operating
erratically when the battery becomes depleted. In this
event, change the battery at your earliest opportunity.
Confirming Battery Life:
When the small button is depressed fully, an LED
indicator will light. If the indicator fails to light, or
lights only dimly, the battery is depleted and should
be replaced.
LED indicator
AAA (LR03) alkaline battery
Mode selector switch
Set the mode switch in
accordance with whether
you will use the special
pen or other device to
input characters and lines
on the screen.
PEN Mode:
In this mode, the
special accessory
pen can be used to write
on the screen. Using the
special pen allows the
drawing of more clearly
delineated characters and
lines.
NORMAL Mode:
In this mode, your
finger or other
object can be used to write
on the screen. This mode
will produce lower screen
definition, however,
compared to drawing with
Plasma Display
Operation Panel
Battery cover