Canon ae1 Installation Procedures Manual page 45

3) From the back of the front cover, remove the fixing
screw, and detach the spanners [I].
<Saddle Finisher-AE2>
1) Open the front cover; then, from the back of the
front cover, remove the fixing screw, and detach the
spanners [I].
Adjusting the Height
1) Loosen the two fixing screws [ l ] each on the front
and rear casters on the pickup side of the finisher.
2) To increase the height of the finisher and the punch-
er unit, t u r n the adjusting bolt [2] in the direction of
the arrow A (A full
turn
of the adjusting bolt will in-
crease the height of the finisher by 1.75 mm.). Refer
to the index while turning the bolt, and perform this
for both front and rear casters.
3) To decrease the height of the finisher and the
puncher unit, t u r n the adjusting bolt [2] in the direc-
tion of the arrow B (A full t u r n of the adjusting bolt
will decrease the height of the finisher by 1.75
mrn.). Refer to the index while turning the bolt, and
perform this for both front and rear casters.