Table of Contents
Advertisement
Options
Off-timer function
Onscreen display
Initial INPUT
Initial VOL level
Maximum VOL level
INPUT lock
Studio W/B
Advanced PIP
Display size
Options
Button lock
Remocon User level
ID select
Remote ID
Serial ID
Slot power
V. lnstallation
Rotate
Press or button to switch between
modes.
Off
On
Off
Does not rotate the image.
On
Rotates the image 180 degrees.
Press
or
button to switch between
modes.
Off
On
Off
Sets fan to the horizontal installation mode.
On
Sets fan to the vertical installation mode.
Notes:
• This functions when display is turned on.
• This mode is available for TH-
42PHD8UK, TH-50PHD8UK.
• Vertical installation is available for
TH-42PWD8UK without this mode
setting.
• Turn up the power switch for the
upward direction when you set Display
vertically.
Press
or
button to switch between
modes.
Off
On
Sets the panel ID Control.
Off
Disables external control by the ID.
On
Enables the external control by the ID.
Normalization
When both main unit buttons and remote control are disabled due to the "Button lock", "Remocon User level" or "Remote
ID" adjustments, set all the values "Off" so that all the buttons are enabled again.
Press the
button on main unit together with
"SHIPPING" menu is displayed and the lock is released when it disappears.
1/2
Press
Off
Enable
Off
On
Sets normal two screen display mode (see page 21).
Off
On
Off
0
Off
0
Sets Advanced PIP mode (see page 22).
Off
Notes:
Off
Off
• When "INPUT lock" is "On", you cannot use all the two screen
Off
display functions.
•
2/2
operation.
Off
Off
Press
0
Off
Off
Off
Adjusts the image display size on screen.
Off
Off
Off
Sets the normal image display size on screen.
Off
On
Sets the image display size approximately 95 % of the normal
image display.
Notes:
• This setting is valid only when the input signals are as follows;
525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i,
1125/24sF, 1125/25p, 1125/24p, 1125/30p, 1250/50i (Component
Video, RGB, DVI, SDI, HDMI)
• This setting is invalid when two screen display, digital zoom or
Multi screen is selected.
• When Display size is set to "On", Pos. /Size adjustment cannot
be used.
• Refer to each board's operating instruction for DVI, SDI, HDMI's
corresponding signals.
Sets panel ID number when panel is used
in "Remote ID" or "Serial ID".
Set value range: 0 - 100
(Standard value: 0)
Press
Off
Off
Disables ID remote control functions.
You can use normal remote control operations.
On
Enable ID remote control functions.
button on the remote control and hold for more than 5 seconds. The
Options Adjustments
or
button to switch between modes.
On
,
buttons are unavailable during Advanced PIP mode
or
button to switch between modes.
On
Off
or
button to switch between modes.
On
On
41
Hide quick links:
Advertisement
Table of Contents
