Table of Contents
Advertisement
Power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
Connecting Power
1.
Turn the machine power switch OFF.
2.
Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
Figure 11. Connecting power.
Disconnecting Power
1.
Turn the machine power switch OFF.
2.
Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
Figure 12. Disconnecting power.
-16-
Test Run
Once the assembly is complete, test run your
bench grinder to make sure it runs properly and
can be put into service.
The test run consists of verifying the following: 1)
The motor powers up and runs correctly, and 2)
that no major vibration exists.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the bench grinder immediately, then review
Troubleshooting on Page 24.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the bench grinder:
1.
Connect the bench grinder to the power
source.
2.
Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the grinder is setup properly.
3.
Make sure all tools and objects used during
setup are cleared away from the area.
4.
Stand to the side of the grinder, and verify
that it is operating correctly by turning it ON.
—When operating correctly, the bench grind-
er runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
bench grinder further. Always disconnect a
machine from power when investigating or
correcting potential problems.
5.
Turn the bench grinder OFF.
Model G9717 (Mfd. Since 3/00)
Advertisement
Table of Contents
