Preparation For Use; Controls And Their Functions - Kenwood vfo-230 Instruction Manual

PREPARATION FOR USE
Connection to THE TS-830S (see Fig. 1)
Connect the supplied Remote cable to the VFO-
230 VFO OUT connector and to the TS-830S EXT
VFO connector. Connect the ground cable to the
G ND terminals of both units.
Note:
1. Ascertain that the TS-830S FIX switch is set
to the VFO position (not depressed).
2. When disconnecting the remote cable, turn the
TS-830S power switch OFF. This procedure
MUST be observed for protection of both the
TS-830S and VFO-230.
CONTROLS AND THEIR FUNCTIONS
FRONT PANEL
1. MEMORY indicator
This LED (light emitting diode) indicates the
memory circuit is ON.
2. VFO indicator
This LED indicates the remote VFO is ON.
3. Main indicator
This LED indicates the TS-830S VFO is ON.
4. Digital display
The digital display indicates true operating frequen-
cy in the range of 100 KHz to 100 Hz order. In the
case of upper zero blanking and 14,000 MHz, the
lower frequency is displayed as L 999.9. When the
frequency is lower than 3.5 MHz, it is displayed as
L 499.9.