Replacing The Feed Roller - Xerox DocuMate 3220 User Manual

Maintenance
2. Squeeze the plastic clamps that hold the pad assembly in place and lift the pad up and out.
Reverse the procedure to replace the new pad into its slots.
3. Close the scanner when you're finished.

Replacing the Feed Roller

The roller will wear out and is designed to be a user-replaceable part. A worn roller can cause
documents to feed in skewed at an angle, or multiple pages to feed at the same time. Before
replacing the roller you should clean it as excessive dust on the roller will make it appear worn and
smooth. You cannot properly diagnose a worn roller until you have cleaned it. You should generally
replace the roller every 160,000 to 200,000 scans.
Replacement parts can be purchased from the Parts & Accessories page for your scanner at
www.xeroxscanners.com.
After replacing a part as described in this section, reset the counter in the scanner properties page
in the Windows Control Panel. On the Device Settings tab, click on the red reset button next the
part counter that you replaced.
User Guide
® ®
Xerox DocuMate 3220 Scanner
31