Assigning A Hybrid Port To A Vlan - HP A3100-8 v2 SI Configuration Manual

Assigning a hybrid port to a VLAN

A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view, Layer 2 aggregate interface view) or port group view.
Follow these steps to assign a hybrid port to one or multiple VLANs:
To do...
Enter system view
Enter
interface
view
(including
Ethernet
interface
view, Layer 2
aggregate
interface
view) or port
group view
Configure the link type of the
port(s) as hybrid
Assign the hybrid port(s) to the
specified VLAN(s)
Configure the PVID of the hybrid
port
NOTE:
• To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
After you use the port link-type { access | hybrid | trunk } command to change the link type of an
•
interface, the loopback detection action configured on the interface by using the loopback-detection
action command will be restored to the default. For more information about the loopback-detection
action command, see the
Before you assign a hybrid port to a VLAN, create the VLAN.
•
After configuring the PVID for a hybrid port, you must use the port hybrid vlan command to configure
•
the hybrid port to allow packets from the PVID to pass through, so that the egress port can forward
packets from the PVID.
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
•
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it
fails to do that on an aggregation member port, it skips the port and moves to the next port.
Use the command...
system-view
Enter Ethernet interface interface-type
interface view interface-number
Enter Layer 2
interface bridge-aggregation
aggregate
interface-number
interface view
Enter port group port-group manual
view port-group-name
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid pvid vlan vlan-id
Layer 2—LAN Switching Command Reference
101
Remarks
—
Required
Use either command.
•
In Ethernet interface view, the
subsequent configurations apply
to the current port.
•
In port group view, the subsequent
configurations apply to all ports in
the port group.
•
In Layer 2 aggregate interface
view, the subsequent
configurations apply to the Layer 2
aggregate interface and all its
member ports.
Required
Required
By default, a hybrid port allows only
packets of VLAN 1 to pass through
untagged.
Optional
VLAN 1 is the default by default.
.