Tormach pathpilot Technical Document

PathPilot Controller Quick Start Guide
™
Product Identification: PathPilot Controller (PN 35286)
Purpose: This document details set up of the PathPilot controller for the PCNC 1100, PCNC 770, PCNC 440,
and the 15L Slant-PRO.
PathPilot Controller (PN 35286)
Item # Connection or Component
1 Power/Reset with LED
2 USB Connectors (4)
3 Optical Drive
4 Hard Drive LED
5 PS/2 Connector
6 USB Connectors (2)
7 DVI Connector
8 VGA Connector
9 DP*
10 HDMI*
11 Blue USB Connectors (4)
12 Ethernet Connector
13 Audio Connections*
14 Machine Interface Port
15 Voltage Setting Switch
16 PCI Expansion Slot
17 AC Power Connector
*NOTE: Do not use these controller features.

Controller Set-up

Position and Location
The PathPilot controller should be placed inside the stand cabinet. This storage area is large enough to
provide adequate cooling without the need for additional fans. It should be positioned either vertically or
horizontally in a location where it will remain clean and dry. If vertical, rest it on rubber pads; if horizontal,
the optical drive should be on top. If the controller cannot be placed in the stand cabinet, it should be placed
in a location that provides similar protection from coolant, chips, etc.
Tormach Inc.
1071 Uniek Drive, Waunakee, WI 53597
Phone: 608.849.8381 / Fax: 209.885.4534
Specifications subject to change without notice.
Page 1
©Tormach® 2014. All rights reserved.
TD10358_PathPilot_Controller_QSG_0216A
3
2
1
4