History Information; Recording Custom Messages; 1: Message Record Mode - Honeywell ECC-50/100 Instruction Manual

Recording Custom Messages

The Version Information screen lists the devices programmed to the ECC system by address. All
software and hardware revision information can be viewed here. This screen is updated every time
a device is added or changed.

History Information

The History Information screen shows the system's event history. A maximum of 100 events can be
viewed, starting with the most recent. This information can be erased by clicking the Clear History
button. Clicking the Print button will activate the print dialog box. Print options are selected in this
box. Note that the Date and Time in the heading of the print screen correspond to those of the panel
and not the computer. The Unit ID reflects the name of the panel assigned in the General Options
page. Refer to "General Options" on page 61.
3.5 Recording Custom Messages
The system has 14 recordable message slots. Messages can be recorded from the microphone,
external audio input, or uploaded via USB using the Voice Loader (VL) software. Each message
can be up to one minute in duration.
3.5.1 Message Record Mode
Enable Recording Mode in the system's message recording programming section. Refer to
Section 3.3.1 on page 68.
While in Local Record mode, zone buttons 1-14 are used to reference message slots 1-14. The asso-
ciated green zone LED will indicate whether a message is currently programmed in the correspond-
ing slot. The associated yellow zone LED will indicate a recording in progress. The zone buttons 1-
14 will be used to play back a recorded message or to reference a message slot that needs to be
recorded or erased.
Zone buttons 17, 19, and 24 are used to control the recording/erasing process.
Emergency Command Center Manual — P/N LS10001-000FL-E:G 5/3/2016
Figure 3.14 History Information
Programming
71