Power/Status And Stack Led Indicators - Aruba S2500 Installation Manual

Table 5 10/100/1000 Ethernet Port LEDs (Continued)
LED
Status

Power/Status and Stack LED Indicators

In addition to the LEDs on each individual port, there are three additional LEDs on the front panel that
provide overall status of the device. These LEDs provide basic monitoring of the overall status of the S2500.
Table 6 Power/Status and Stack LEDs
LED
Power
Status
Aruba S2500 Series Mobility Access Switch
Function LCD Mode
Port status Administrative
Duplex
PoE
Speed
Fault
Function Indicator
Input power status/ Green (Solid)
system status
Off
Module status Green (Solid)
Green (Blinking)
Amber (Blinking)
Amber (Solid)
Off
| Installation Guide
Indicator Status
Green (Solid) Port Enabled
Off Port Administratively Disabled
Green (Solid) Full-duplex
Off Half-duplex
Green (Solid) PoE Enabled
Green (Blinking) Power enabled, but power denied due to
unavailability
Off PoE not enabled
Green (Solid) 1000 Mbps
Off 10/100 Mbps
Green (blinking) Indicates port security errors. Port security errors
could be the following:
MAC limit exceeded

Loop is detected through loop-protect

 RA guard error
 BPDU guard error
Off N/A
Status
Power On
Power Off
Operational
Device is loading software (on initial start only)
Major Alarm
Critical Alarm
System is not booting
S2500 Mobility Access Switch | 11