Table of Contents
Advertisement
Chapter 1 General Description
4.
Names and Functions of Parts
Names and functions of parts are as follows.
4.1
Front of the server
3.5-inch Hard Disk Drive model
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(1) Air duct
To take air to cool the server
(2) POWER switch
The switch to turn the server on and off. Press once to turn
on the server. The LED lights green when it is on. Press it
again to turn off the server. Hold down the switch for 4
seconds or more to forcibly turn off the server.
(3) Power LED (green)
This LED lights green when the power is ON.
(4) Disk access LED (green/amber)
This LED lights or flashes green when the internal Hard
Disk Drive is being accessed.
(5) Status LED (green/amber)
This LED indicates the server status. It lights green when
the server is operating normally.
(6) Front USB connectors
These connectors are used to connect devices that support
the USB interface.
(9)
(7) Front bezel
This cover protects the front part of the server. Remove this
to handle 3.5-inch device and Hard Disk Drives.
(8) Stabilizer
To mount the server vertically, install as shown in the image
(9) Release tabs (3 at side of front bezel)
Tabs to unlock the front bezel. Pull up to disengage the
front bezel.
(10) Optical disk drive
Reads data from (or writes data to) the disk.
The drive provides the following: an eject button to eject the
tray; an LED that indicates Hard Disk Drive access; and an
eject hole for forcibly ejecting the tray
(11) 3.5-inch device bay
The bay which can accommodate 3.5-inch device.
Express5800/GT110d-S User's Guide
4. Names and Functions of Parts
Front bezel removed
(10)
(11)
31
Advertisement
Table of Contents
