Specifications - Panasonic DVD-LX9 Operating Instructions Manual

Troubleshooting Guide
Picture
The SETUP menus ≥The unit and television are using different video systems.
[Units\for\the\United\Kingdom,\Continental\Europe,\Australia\and\N.Z.\
and other screens
shown on the Use a multi-system or PAL television.
television are [Units\for\Asia]
displayed incorrectly. Use a multi-system or NTSC television.
Colors appear faded.
Displays
GUI screens are cut ≥Use [3, 4] while the Bar position icon is highlighted to move them
off. down. P
No On-Screen display. ≥Go to the Display menu in the SETUP screen, and select "On" for
"On-Screen Messages". X
"Check the disc." ≥Clean the disc. 9
"The progressive out is ≥Go to Video in the SETUP menus, and select "Enable" in
set to "Disable"" "Progressive Out (Component)". W
"X" ≥You are trying to play incompatible or corrupted data. This data
cannot be played.
"CHECK CARD" ≥The card cannot be played.
"NO FILE" ≥Data the unit can play is not recorded on the card.
"PLEASE ≥Turn the unit off and on again. Alternatively, turn the unit off,
RE-OPERATE" disconnect the power source (AC or battery pack) reconnect the
power and turn the unit on again.
" ERROR 01" ≥A problem has occurred with the battery pack. Consult your dealer.
" ERROR 02" ≥The battery pack has been recharging for 12 hours but has failed to
recharge for some reason. Recharge again.
" ERROR 03" ≥You are recharging in a location that is too hot or too cold.
Recharge at normal temperature.
"H ∑∑" ≥Trouble has occurred. The number appearing after H depends on
∑∑ stands for a the problem. Turn the unit off and on again. Alternatively, turn the
number. unit off, disconnect the power source (AC or battery pack) reconnect
"U11" the power and turn the unit on again.
If the service numbers fail to clear, note the service number and
contact a qualified service person.
[Í] and [CHG] indicators
The [Í] indicator ≥The unit has malfunctioned. Consult your dealer.
flashes rapidly.
The [Í] indicator ≥The unit is on and the LCD is closed or the display mode is set to
flashes slowly. "OFF" (no picture). Turn the unit off when you have finished.
The [CHG] indicator ≥There is a problem with the battery pack. Turn the unit on and check
flashes rapidly. the message on the LCD (see above).
The [CHG] indicator ≥Battery pack charge is low. The unit will turn off automatically after a
flashes slowly. few minutes. =
Note
The following do not indicate malfunction.
≥Sound from the AC adaptor during recharging.
≥The battery pack warming up when recharging or during use.
46
≥The surface and area around the card slot becoming warm when used over long periods.

Specifications

∫ Main unit
Discs played: DVD-RAM (DVD-VR format)
DVD-Video, DVD-Audio
Music CD [CD-DA (CD-TEXT compatible)]
Video CD,
CD-R/CD-RW [CD-DA (CD-TEXT compatible),
Video CD, MP3, WMA, JPEG,
HighMAT Level 2 (Audio and Image)]
DVD-R (finalized as DVD-Video)
SD played:
Media: SD Memory Card
Image: JPEG
Video: MPEG4
Voice: G.726
Audio: MPEG2-AAC, MP3
(Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz)
Signal system:
[For\the\United\Kingdom,\Continental\Europe,\
\Australia\and\N.Z.\
PAL/PAL60/NTSC
[For\Asia] NTSC/PAL60/PAL
9q α-Si, TFT wide-screen LCD
LCD screen:
(VGA 800k480kRGB pixels)
Composite-video output/input :
§1
Output/input §1 level: 1 Vp-p (75 ≠)
Output/input terminal: Mini-jack
§1
Number of terminals: 1 system (output/input
Audio output/input :
§1
Output/input §1 level: 1.5 Vrms (1 kHz, 0 dB, 10 k≠)
Output/input terminal: Stereo mini-jack
§1
Number of terminals: 1 system (output/input
Audio performance:
(1) Frequency response:
(1) ≥DVD (linear audio):
4 Hz–22 kHz (48 kHz sampling)
4 Hz–44 kHz (96 kHz sampling)
(1) ≥DVD-Audio: 4 Hz–88 kHz (192 kHz sampling)
(1) ≥CD audio: 4 Hz–20 kHz
(2) S/N:
(1) ≥CD audio: 115 dB
(3) Dynamic range:
(1) ≥DVD (linear audio): 98 dB
(1) ≥CD audio: 97 dB
(4) Total harmonic distortion:
(1) ≥CD audio: 0.008 %
Digital audio output:
Output terminal: Mini optical terminal
Number of terminals: 1 system
(also used for audio output/input
Built-in speakers: 1 Wi1 W stereo output
Pickup: Wave length: 658 nm/790 nm
Laser power: CLASS 2/CLASS 1
NORSK
Pickup
Bølgelengde: 658 nm/790 nm
Laserstyrke: Ingen farlig stråling sendes ut
(med sikkerhets-beskyttelse)
KLASSE 2/KLASSE 1
Power supply: DC 9 V (DC IN terminal)/
DC 7.2 V (Battery terminal)
Power consumption (using included AC adaptor):
18 W (Unit only: 13 W)/Recharging 14 W
Battery pack CGR-H604 (lithium ion):
Voltage:
Capacity:
Dimensions (excluding protrusions):
232 (W)k173.5 (D)k30.7
Mass:
∫ Multi cradle
Composite-video output:
Output level: 1 Vp-p (75 ≠)
Output terminal: RCA pin-jack
Number of terminals:
S-video output:
Y output level: 1 Vp-p (75 ≠)
C output level:
[For\the\United\Kingdom,\Continental\Europe,\
\Australia\and\N.Z.\
0.3 Vp-p (75 ≠)
[For\Asia] 0.286 Vp-p (75 ≠)
Output terminal: S-video jack
Number of terminals:
Component-video output
[Progressive compatible (NTSC only)]:
Y output level: 1 Vp-p (75 ≠)
P output level: 0.525 Vp-p (75 ≠)
B
§1 ) P output level: 0.525 Vp-p (75 ≠)
R
Output terminal: RCA pin-jack
Number of terminals:
Audio output:
§1 ) Output level: 1.5 Vrms (1 kHz, 0 dB, 10 k≠)
Output terminal: RCA pin-jack
Number of terminals: 5.1 ch discreet output
Included speakers: 2 Wi2 W stereo output
Power supply: DC 9 V (DC IN terminal)
Power consumption (using included AC adaptor):
28 W (when connected to main unit and playing)
Dimensions (excluding protrusions):
238 (W)k182 (D)k38 (H) mm
Mass:
∫ Common
Operating temperature range: i5 to i35 oC
Operating humidity range:
10–80 % RH (no condensation)
AC adaptor:
Power source: AC 100–240 V, 50/60 Hz
Power consumption:
) DC output: 9 V, 2500 mA
§1
Note
Specifications are subject to change without notice.
Mass and dimensions are approximate.
Audio/video input is for Asia only.
§1
24.6 mm at lowest point
§2
Power consumption in standby mode
(using included AC adaptor):
Main unit:
Multi cradle: 0.9 W (when connected to main unit)
7.2 V
3000 mAh
(H) mm
§2
1200 g
1 system
1 system
1 system
1 system
680 g
38 W
0.8 W
47