NEC D3-10i Quick Start Manual page 43

22. If you click Bind/Select in Step 21, the
Bind/Select window will allow you to create a
pool and assign physical drives to that pool in a
specified RAID configuration.
When the needed logical drives and pools have
been configured, click OK to continue.
23. After setting the logical disk binding parameters,
a confirmation window will appear. Review the
settings and license information listed, and if
everything is correct, click Set. Otherwise, click
Back and configure the proper settings before
continuing.
24. After configuring logical disks and confirming that
all settings are correct, the array will begin
setting the configuration and building any logical
disks that may have been configured. When the
initialization process is complete, an Initialization
Complete window will appear.
At this point, click Finish to complete the
initialization, and then confirm that all configured
logical drives and application servers are
connected through the Storage Manager client.
NEC D3-10i Quick Start Guide 41