Radio - Panasonic CQ-C3301N Operating Instructions Manual

E

Radio

N
G
L
I
S
H
[SRC: Source] (Stereo) indicator
9
PWR
SRC SRC
AF SCROLL
MUTE
TA
1 1 2 2 3 3
SQ
Preset Buttons [1] to [6]
(Preset station)
q
Radio Mode
Press [SRC] to select the radio mode.
Preset number
Band Frequency
w
Band
Press [BAND].
e
Tuning
[[]: Higher frequency
[]]: Lower frequency
Press and hold [[] or []] for more than 0.5
seconds, then release it. Seeking will start.
10
CQ-C3301N
[]] [[] (TUNE)
OPEN
CQ-C3301N
BAND BAND
APM APM
[BAND]
(APM: Auto Preset Memory)
RANDOM SCAN REPEAT PTY
DISP DISP
4 4 5 5 6 6
[DISP] (Display)
Note:
¡ For tuning in to only stations whose receiving condi-
tions are good in the seeking mode, set LOCAL to ON.
(a Page 28)
¡ For reducing noise when a receiving FM stereo wave is
weak, set FM MONO to ON. (a Page 28)
Display Change
Press [DISP] to change the display as follows.
3 AM (LW/MW) 3FM (non RDS)
Frequency Frequency
Clock Time (CT) * PS (Programme
Service Name)
Clock Time (CT) *
*Adjust the clock when "NO CT" appears on the screen.
(Clock setting a Page 9 )
Station Preset
Up to 6 stations can be stored in each of the FM1, FM2, FM3 and AM (LW/MW) band selections.
Note:
¡ New stations overwrite existing saved stations after these procedures.
Warning
¡To ensure safety, never attempt to preset stations while you are driving.
Auto Preset Memory (APM)
With this operation, stations with good receiving condi-
tions can be automatically stored in the preset memory.
q Select a band.
(a Previous page)
w Press and hold [BAND] (APM) for more than 2 sec-
onds.
6 stations with first to 6th highest in signal strength will
be preset to each band.
Once set, the preset stations are sequentially scanned
for 5 seconds each. (scanning)
Note:
¡ To stop scanning, press one of the buttons from [1] to
[6].
¡ Only RDS stations will be saved at default setting (AF
ON). To select non-RDS stations, set AF to
OFF. (a Page 13)
Preset Station Calling
q Select a band.
(a Previous page)
w Press one of the preset buttons from [1] to [6].
Manual Preset Memory
With this operation, a station can be manually stored in the
preset memory.
q Select a band and frequency.
(a Previous page)
w Press and hold one of the preset buttons from [1] to [6]
until the display blinks once.
Preset number
CQ-C3301N
E
N
G
L
I
S
H
10
11