[Auto] - Panasonic DMW-FL360 Operating Instructions Manual

[AUTO]

Press the [MODE] button, and select
the flash mode. (P17)
≥
The flash working range is shown
on the display panel in line with the
settings of the digital camera.
A: Flash working range
≥
If the settings on the digital camera
(ISO sensitivity and aperture) are
outside the combinations of the ISO
sensitivity and aperture which can
be adjusted, the flash working range
is not displayed and the user is
warned by the flashing of [ISO] and
[F] on the display. In a case like this,
change the digital camera settings.
1 Check that the distance to
the subject is within the
flash working range.
≥
If the subject is outside the range,
adjust the aperture of the lens or
change the distance to the subject.
≥
The flash working range changes
depending on the type and
settings (ISO sensitivity, aperture
and focal length) of the digital
camera used.
2 Press the shutter button
all the way down, and take
the picture.
20
VQT1B11
A
3 Check that the [AUTO
CHECK] lamp is flashing.
≥
If the [AUTO CHECK] lamp
continues to flash for about
5 seconds, it means that the unit
has fired successfully. If it does not
flash, the unit has not fired
successfully. Check the settings
on the unit and the digital camera
and then take the picture again.
∫
Combinations of the ISO
sensitivity and aperture which
can be adjusted in the [AUTO]
mode
ISO sensitivity
3200
1600
800
400
200
100
50
25
AUTO CHECK
Aperture
F8 to F32
F5.6 to F32
F4 to F32
F2.8 to F32
F2 to F32
F1.4 to F22
F1.4 to F16
F1.4 to F11