Set-Up As Either A Building Back-Up Or Portable Power Source - NorthStar 165165 Product Manual

3. Set-up as either a BUILDING BACK-UP or PORTABLE Power Source

This generator is designed to provide up to 6500W of electrical power. It can supply electricity in
two ways:
1. As a back up, standby power source for a building. For this application, you must arrange
for a licensed electrician to connect the generator to your building's electrical system via the
installation of an UL-listed transfer switch. The transfer switch must be installed in
accordance with building electrical code and guidelines supplied by your power company.
2. As a portable power source. You can plug appliances or tools directly into the generator's
electrical outlets.
Specific requirements for each are given below.
Note: Regardless of whether you use your generator as a back-up power source connected to a
building or as a portable power source, you must not overload the generator. Overloading
may cause serious damage to the generator and attached electrical devices.
Using as a
Back-up Power
Source for a
Building
Installation / Initial Set-Up
Contact a licensed electrician to install a UL-listed transfer switch if you
want to use your generator as a back-up power source for a building.
What does a transfer switch do? It:
a) Safely connects the generator to your building's electrical system by
isolating your generator from your utility company's power lines,
AND
b) Connects your generator to a critical subset of your building's circuits
that are needed for emergency power needs.
If your generator will be connected to your building's electrical system, it
MUST ALWAYS be isolated from the utility power grid with a UL-listed
transfer switch installed by a licensed electrician in compliance with all
applicable building and electrical codes, and in accordance with guidelines
supplied by your power company.
DANGER:
A transfer switch must be installed in order to isolate your
generator from the utility power grid. If your generator is NOT
properly isolated from the utility system, serious hazards will
arise:
 When your generator is running, its output will back feed into
the utility power line and transformer that are normally used to
provide you with power. The transformer will step up the
current to the normal line voltage. An unsuspecting utility line
worker working on what he thinks is a deactivated line could
be electrocuted.
 If your generator is connected (running or not) when utility
power is restored, your generator will be destroyed. It could
also explode or cause fire.
In addition to isolating your generator from the utility system, the transfer
switch connects your generator to a limited set of circuits in your building
that have been chosen as critical to operate during a power outage.
13