Page 2
12. Do not install with a method which is not approved in the instructions.
Page 3
These Panasonic ventilating fan models are equipped with a motion sensor and a humidity sensor that turn on automatically when motion is detected, when humidity increases rapidly, or when humidity rises above a 30% 80% relative humidity set-point. It is user-adjustable to operate 0.5...
Page 4
Motion sensor unit Humidity sensor unit Fan body Junction box Main control circuit AC120V White White Neutral 60Hz Live VENT. Black Black Capacitor (Power supply) White White Yellow Motor Black White (114 C Fuse in Motor) lmpedance-protected Humidity sensor Black Black Green (Earth ground)
Page 5
Humidity preset switch positions (Tolerance:±10%) MIN MAX Factory setting: 50% RH (" " means "about") Timer preset switch positions Timer Position : refer to 0.5 minute Panasonic ventilating fan responds to: (1) Motion sensor detectible condition. (2) Humidity sensor detectible condition. Room temperature is (77 F).
Page 7
4. Install a circular duct and secure it with clamps, or wire ties and seal it with mastic or masitc tape. A 4 or 6 inch circular duct is needed to connect to the relevant part of adaptor. (Fig.3) Mastic tape Motion sensor unit page 4...
Page 8
(3 position) (Fig.6). 9. Adjust timer preset switch and humidity preset switch (Fig.7). Refer to switch indication on page 5.
Page 10
4. Do not use cleaning sprays, solvents, or water on or near the sensors. Remove grille by pulling down the mounting spring opposite the sensor lead.
Page 11
Use the shortest, straightest duct routing possible for best performance, and avoid installing the fan with smaller ducts than recommended. Insulation around the ducts can reduce energy loss and inhibit mold growth. Fans installed with existing ducts may not achieve their rated air flow. FV-08VQC5 15.5 FV-11VQC5 23.0...