Remote Specifications - Panasonic BT-LH1700W Operating Instructions Manual

REMOTE Specifications

REMOTE operation is possible on this monitor using the GPI/RS-232C terminal.
GPI terminal
Each of the items in the GPI screen are compatible with the following terminals.
You can assign functions to each terminal in the menu GPI screen (
The functions assigned to each terminal operate when the GND (5 Pin) is connected (ON) or open (OFF).
GPI Terminal (9P)
Assignment items Function
UNDEF
No settings (no terminal assignment functions)
MARKER1
Switches the marker display of the marker
ON/OFF
decided in "GPI PRESET1" (
"MARKER" menu.
MARKER2
Switches the marker display of the marker
ON/OFF
decided in "GPI PRESET2" (
"MARKER" menu.
MARKER
Reduces the brightness of the background
BACKHALF
outside the marker displayed in "GPI PRESET1"
(
MARKER
Reduces the brightness of the background
BACKBLACK
outside the marker displayed in "GPI PRESET1"
(
CENTER MARKER
Switches the center marker display ON/OFF.
(When other markers are being displayed, this is
superimposed on the other markers)
INPUT SEL. VIDEO
Switches the input system to VIDEO.
INPUT SEL. Y/C
Switches the input system to Y/C.
INPUT SEL. SDI1
Switches the input system to SDI1.
INPUT SEL. SDI2
Switches the input system to SDI2.
INPUT SEL.
Switches the input system to YP
YP P /RGB
B R
SD ASPECT
Sets the aspect ratio settings when using SD signal
input. (Disabled when using HD signal and PC signal)
SCAN
You can switch the scan mode between "UNDER"
and "NORMAL". (Disabled when using PC signal)
*1
Lights the red tally.
R-TALLY
*1
Lights the green tally.
G-TALLY
MONO
Switches between color and monochrome
(MONO). (Disabled when using PC signal)
GAMMA SELECT
Used to select the gamma curve. (Disabled when
using PC signal)
*2
Selects the SYNC when using RGB-VIDEO
RGB SYNC
input.
*1 When both "R-TALLY" and "G-TALLY" are ON at the same time, the tally color becomes orange.
*2 This is only enabled when "RGB-VIDEO" is selected in "YP
Pin number Signal
1 GPI1
2 GPI2
3 GPI3
4 GPI4
5 GND
6 GPI5
7 GPI6
8 GPI7
9 GPI8
page 14) by 50%.
page 14) to 0%.
page 20).
g Operating conditions
Level operation: operates when GND is connected.
Edge operation: operates when GND changes from
open to connected.
* If you have assigned a level operation function to more
than one terminal, the function operates as long as
one of the terminals is connected.
Operating conditions
—
Level operation
page 14) in the (Connected: ON, Open: OFF)
Level operation
page 14) in the (Connected: ON, Open: OFF)
Level operation
(Connected: ON, Open: OFF)
Level operation
(Connected: ON, Open: OFF)
Level operation
(Connected: ON, Open: OFF)
Edge operation
Edge operation
Edge operation
Edge operation
P /RGB. Edge operation
B R
Level operation
(Connected: 16:9, Open: 4:3)
Level operation(Connected: UNDER,
Open: NORMAL)
Level operation
(Connected: ON, Open: OFF)
Level operation
(Connected: ON, Open: OFF)
Level operation (Connected:
Monochrome, Open: Color)
Level operation (Connected: FILM
mode, Open: NORMAL mode)
Level operation
(Connected: EXT, Open: G-ON)
P /RGB" in the "INPUT SELECT" menu.
B R
23