Flex State Parameters - GE F35 Instruction Manual

CHAPTER 5: SETTINGS
Figure 5-39: User-programmable pushbutton logic (Sheet 2 of 2)
LATCHED
From user-programmable
pushbuttons logic
sheet 1, 842021A3
LATCHED/SELF-RESET
PUSHBUTTON ON
SETTING
Message Priority
Instantaneous reset will be executed if any
front panel button is pressed or any new
target or message becomes active.
FLEXLOGIC OPERAND
PUSHBUTTON 1 ON
PUSHBUTTON 2 ON
PUSHBUTTON 3 ON
PUSHBUTTON 16 ON
The enhanced front panel has 16 operands;
the standard front panel has 12
User-programmable pushbuttons require a type HP or HQ faceplate. If an HP or HQ type faceplate was ordered
separately, the relay order code must be changed to indicate the correct faceplate option. This can be done in
NOTE the EnerVista software with the Maintenance > Enable Pushbutton command.

5.3.15 Flex state parameters

SETTINGS  PRODUCT SETUP  FLEX STATE PARAMETERS
 FLEX STATE
 PARAMETERS
This feature provides a mechanism where any of 256 selected FlexLogic operand states can be used for efficient
monitoring. The feature allows user-customized access to the FlexLogic operand states in the relay. The state bits are
packed so that 16 states are readable in a single Modbus register. The state bits can be configured so that all states of
interest are available in a minimum number of Modbus registers.
F35 MULTIPLE FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
OR
AND
AND
= Disabled
= High Priority
= Normal
AND
FLEXLOGIC OPERAND
ANY PB ON
OR
PARAMETER 1:

Off

PARAMETER 256:

Off
SETTING
Flash Message Time
0
AND
T
RST
Instantaneous
reset *
The message is temporarily removed if
any keypad button is pressed. Ten (10)
seconds of keypad inactivity restores
the message.
OR
SETTING
Flash Message Time
0
T
RST
Instantaneous
reset *
1. If pushbutton 1 LED control is set to off.
FLEXLOGIC OPERAND
PUSHBUTTON 1 ON
2. If pushbutton 1 LED control is not set to off.
SETTING
PUSHBTN 1 LED CTL
= any FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
PRODUCT SETUP
LCD MESSAGE
ENGAGE MESSAGE
SETTINGS
Top Text
= XXXXXXXXXX
On Text
= XXXXXXXXXX
FLEXLOGIC OPERAND
PUSHBUTTON 1 OFF
FLEXLOGIC OPERAND
PUSHBUTTON 1 ON
LCD MESSAGE
ENGAGE MESSAGE
SETTINGS
Top Text
= XXXXXXXXXX
On Text
= XXXXXXXXXX
PUSHBUTTON 1 LED LOGIC
Pushbutton 1
LED
Pushbutton 1
LED
842024A2.CDR
5-103
5