Clear Config; Tv-Ip420P; Restore Default Password; Software Reset - TRENDnet TV-IP420P User Manual

TRENDnet User's Guide
Clear Config
You can clear PTZ configurations all at once in this section, select the desire function and click
Save to clear.
© Copyright 2016 TRENDnet. All Rights Reserved.
Restore Default Password
Software Reset
Refer to Advanced Settings, Maintenance section.
Hardware Reset
Follow the steps to perform a hardware reset
1. Disconnect the power source (Network Cable from PoE injector or switch) e from
the camera
2. Open the back cover behind the lens and find the reset button
3. Press and hold the reset button then connects the power source (Network Cable
from PoE injector or switch) back to the device. Release the reset button after 20
seconds. Wait for 1 minute for camera to reboot. The device has now been reset.
4. Login to the camera to see if the password has been reset.
5. Close the cover and configure the camera again.
TV‐IP420P
57