Connecting Madsen Itera Ii To Otosuite; Connecting Accessories To Madsen Itera Ii - otometrics madsen itera ii User Manual

6

Connecting MADSEN Itera II to OTOsuite

Launching OTOsuite
When you use MADSEN Itera II for the first time, run the Configuration Wizard to set up the connection between MADSEN
Itera II and OTOsuite. After you have configured OTOsuite for the first time, if MADSEN Itera II is turned on when you
open the Control Panel in OTOsuite, then MADSEN Itera II will connect to OTOsuite automatically. Otherwise, you can
connect MADSEN Itera II as follows:
1. Switch on the device.
2. Launch OTOsuite.
3. In the OTOsuite toolbar, click
4. In the Control Panel, click
Connecting to OTOsuite
• Run the OTOsuite Configuration Wizard to connect to and set up communication with MADSEN Itera II: Select
Configuration Wizard...
Click the
7

Connecting accessories to MADSEN Itera II

1. When selecting accessories connected to the RS232 socket and DC output of the device, the following
General warning notes ► 23
See
See also Installation ► 5
For a detailed description of the connection panel, see the MADSEN Itera II Reference Manual.
7.1 Air conduction
See Installation ► 5
Headphones
• Connect the right and left cables (red and blue) from the transducers to the right and left AC sockets in the rear panel
of MADSEN Itera II.
Otometrics - MADSEN Itera II
Control Panel
Connect
.
Configure Audiometry
button next to
points must be considered:
– Use of connected equipment in a patient environment
– Proof that connected equipment has been tested in accordance with Medical Electrical Systems in IEC
60601-1 3.1 edition: 2012, ANSI/AAMI ES60601-1 (2005) + AMD 1 (2012) and CAN/CSA-C22.2 No.
60601-1 (2014).
.
.
for an overview of the connection panel.
.
and connect to the device as described in the OTOsuite User Guide.
6 Connecting MADSEN Itera II to OTOsuite
Tools
>
7