Other External Components; Using Rear View Camera - Kenwood DDX374BT Instruction Manual

OTHER EXTERNAL COMPONENTS

OTHER EXTERNAL COMPONENTS

Using rear view camera

• To connect a rear view camera, see page 66.
• To use a rear view camera, a REVERSE lead
connection is required. (Page 64)
❏ Settings for the rear view camera
1
Display the <Input> settings screen.
On the Home screen:
2
Display the <Rear Camera> screen.
3
[ON] Displays the picture from the rear view
camera when you shift the gear to the
reverse (R) position.
[OFF] Select this when no camera is
connected.
❏ Displaying the rear view camera screen
The rear view screen is displayed when you shift the
gear to the reverse (R) position.
• To remove the caution message, touch the screen.
To display the picture from the connected
camera manually
On the pop-up short-cut menu (Page 10):
Display the pop-up short-cut menu by pressing
MENU on the monitor panel, then select [Camera].
On the monitor panel:
DDX374BT
DDX340BT/DDX24BT
To exit the camera screen
On the camera screen:
Touch the area shown below.
On the monitor panel:
DDX374BT
DDX340BT/DDX24BT
To adjust the picture
While the camera screen is displayed...
(Hold)
• The picture adjustment menu is displayed.
(Page 52)
To close the picture adjustment menu, touch the
same area again.
(Hold)
ENGLISH 37