Remote Control; To Erase The Memory - Craftsman 139.10158 Owner's Manual

Remote Control

Your remote control has been programmed at the factory to
operate with your garage door opener.
Older Craftsman remote controls are NOT compatible.
Programming can be done through the learn button on the garage
door opener. To program additional accessories refer to the
instructions provided with the accessory or visit
www.craftsman.com. If your vehicle is equipped with a
®
Homelink , you may require an external adapter depending on the
make, model, and year of your vehicle. Visit www.homelink.com
for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE
CONTROL/KEYLESS ENTRY PIN
1. Press and immediately release the Learn button.
2. Remote Control: Press and hold the button on the remote
control that you wish to use.
Keyless Entry: Enter a 4-digit personal identification number
(PIN) of your choice on the keyless entry keypad. Then press
the ENTER button.
The garage door opener lights will flash (or two clicks will be
heard) when the code has been programmed. Repeat the steps for
programming additional remote controls or keyless entry devices.
1
LEARN LED
2
OR
?
LEARN
Button
? ? ?
PIN

To Erase the Memory

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the LEARN button on garage door opener until
the learn LED goes out (approximately 6 seconds). All remote
control and keyless entry codes are now erased. Reprogram
any accessory you wish to use.
ERASE ALL REMOTE CONTROLS, KEYLESS ENTRIES AND
SMART CONTROL DEVICES FROM GARAGE DOOR OPENER
1. Press and hold the learn button on garage door opener until
the learn LED goes out (approximately 6 seconds).
2. Immediately press and hold the learn button again until the
learn LED goes out. All codes are now erased.
Reprogram any accessory you wish to use.
33