Setting The Alarm Clock - DigiTech AR1945 Owner's Manual

SETTING THE ALARM CLOCK

There are two different alarm modes to choose from, TIMER A and
TIMER B. You can choose to wake up the radio or to buzzer tone.
1) Quickly press TIMER A or B button to display TIMER A or TIMER B
alarm time; and
2) To set the alarm time, if the alarm is deactivated, press and hold
the button for two seconds
in the display.
3) While they are flashing, directly enter digits by pressing numeric
keys (0-9) to set HOUR and MINUTE. Press the TIMER A or B button
again to confirm finishing setting.
(Note: directly enter 4 digits either in 12 hour or 24 hour mode)
4) If the alarm is activated, hold the button down for 2 seconds to
shut down dual alarm and will not enter dual alarm setting.
5) To set TIMER B alarm, repeat the same procedure as described
for TIMER A.
USING KEY LIGHT SWITCH
(right side of radio)
Flip this switch to ON to make the keys light when they are pressed.
Flip it to OFF to shut down this feature.
USING THE LINE IN/ OUT SOCKETS
(right side of radio)
These sockets are on the right side of the unit, an 1/8 inch stereo
type (3.5mm), An external audio device (such as an MP3 player) can
be played by connecting an AUX line from the device into the Line-in
socket. The Line out socket can be used to feed audio from the unit
to amplified external speakers.
14
until word "TIMER A" begins to flash