Starting Up The 2In1 Tablet For The First Time; Charging The 2In1 Tablet - Silvercrest ST10432-10d Operating Instructions Manual

7) Starting up the 2in1 Tablet for the first time

First unpack your tablet. Remove all components from the packaging
and completely remove the packaging material, including the
protective film. Check to ensure that the delivery is complete (see
Section 5).
If you find that there are components missing or damaged, contact
customer service immediately.

Charging the 2in1 Tablet

Please fully charge your tablet before you use it for the first time.
To charge the tablet, connect the USB 2.0 plug of the USB 2.0 cable
provided to the power adapter and connect the Micro-USB plug of
the cable to the tablet. Now plug the power adapter into a socket.
The charging LED flashes blue while the device is charging.
Once the battery is fully charged, the charging LED is permanently
illuminated blue.
i
NOTE
If the charging LED flashes blue when the charger is not
connected, this indicates that the battery level is low.
Please charge the tablet if this is the case.
i
NOTE
Only leave the power adapter connected to the power
socket until the tablet is fully charged.
Once charged, disconnect the power adapter from the socket
first and then remove the charging cable from your tablet.
i
NOTE
The maximum battery life is reached after approximately
10 charging cycles.
GB 22