Date And Time Settings; Connection Of The Rs485 Line And Inverter Acquisition Check - Aurora PVI-AEC-EVO Quick Installation Manual

PVI-AEC-EVO / PVI-AEC-EVO LIGHT
QUICK INSTALLATION GUIDE
F.

Date and time settings

1. Enter the main menu as administrator (See par.'C').
2. Access the menu 'SETTINGS' > 'DATALOGGER'
correct date in the system.
3. Return to the menu 'DATALOGGER'
in the system.
PVI-AEC-EVO ......
12.00.00 01/01/11
>settings
change password
>set date
set time
>set time
network
G. Connection of the RS485 line and inverter acquisition
check
The connection of the RS485 line must be carried out respecting the pin-outs of the J15 and/or J17 connectors.
Note: For PVI-AEC-EVO LIGHT, the only usable RS485 port for inverter monitoring is the RS485/2,
correspondent to connector J15.
I
t is recommended to connect the RS485 line when all the equipment is switched off (both the monitoring system
and the inverters) and to start up the monitoring system first and then the inverters. It is recommended to:
l
Use a cable for RS485 applications with the following characteristics: 1 twisted pair + 1 conductor or two
twisted pairs, Screen and characteristic Impedance equal to 120 . For further information on the cable to be
used refer to Appendix 2.
l
Make sure the signals correspond.
l
Make sure that all three lines (+T/R,-T/R and RTN) are connected according to the diagrams in pages 9 - 10.
l
Make sure that the communication line screen is grounded according to the diagrams in pages 9 - 10).
l
Make sure that each element in the chain (each inverter or each 55kW module) has a RS485 address that is
different from the others.This address can be set via the display of the inverter.
and then select the
and then select the 'SET TIME'
menu pin
0***
ENTER
>datalogger
io settings
ENTER
>set date
01/01/11
ENTER
>set time
12.00.00
ENTER
7 - EN
'SET DATE' sub-menu. This enables to set the
sub-menu. This enables to set the correct time
SET PIN TO 0010
CHANGE VALUE
ENTER
CHANGE VALUE
CHANGE VALUE
Ω
NEXT
ENTER
DIGIT
NEXT
ENTER
FIELD
NEXT
ENTER
FIELD