To View Or Configure The Ip Address For The Server Module Sp Using Static Ip Addresses - Through The Ucp - Sun Oracle BLADE T6320 Installation Manual

b. Write down the MAC address and use it to configure your DHCP server.
5. View the IP address that DHCP has assigned to the server module SP.
After a valid IP address has been assigned to the server module, view the IP
address. Refer to
▼ To View or Configure the IP Address for the Server
Module SP Using Static IP Addresses — Through the
UCP
1. Connect to the server module SP through the front-panel UCP using a dongle
cable.
Refer to
2. (Optional) View the IP address.
■
.
-> show /SP/network
■
-> show /SP/network ipaddress
3. Follow the instructions in
Module SP Using Static IP Addresses — Through the CMM" on page
with
After you have finished following those steps, proceed to
4. When you are done, exit from the ILOM software on the SP by typing exit.
■
■
24 Sun Blade T6320 Server Module Installation Guide • April 2010
Step 3.
"Connecting to the Server Module SP Using a Dongle Cable" on page
To see all the IP address-related information, type:
To see only the IP address, type:
Step 3.
If you connected to the server module ILOM through the CMM ILOM, you
will be returned to the CMM ILOM.
If you connected to the ILOM using SSH, you will be disconnected
automatically, because you logged in under a different IP address.
"To View or Configure the IP Address for the Server
17.
20, starting
Step 4, below.