Bosch DINION IP 7000 HD Installation Manual page 39

DINION IP 7000 HD
Assigning an IP Address
Before you can operate a camera in your network you must first
assign it an IP address that is valid for your network.
The following default address is preset at the factory:
192.168.0.1
1.
2.
3.
4.
5.
6.
Note:
You must reboot to activate the new IP address, a new subnet
mask, or a gateway IP address.
Reboot
Briefly interrupt the power supply to the camera for a reboot
(disconnect the power supply and switch on again after a few
seconds).
Additional Parameters
Use the terminal program to check other basic parameters and
modify them where necessary. Use the on-screen commands in
the various submenus to do this.
Bosch Security Systems
Start a terminal program such as HyperTerminal.
Enter the user name service. The terminal program displays
the main menu.
Enter command 1 to open the IP menu.
Enter 1 again. The terminal program displays the current IP
address and prompts you to enter a new IP address.
Enter the desired IP address and press Enter. The terminal
program displays the new IP address.
Use the displayed commands for any additional settings you
require.
Troubleshooting | en
2014.09 | v1.0 | AM18-Q0674
39