Motorola VC70N0 Quick Reference Manual page 9

Quick Reference Guide
U Mount Installation
The U Mount (P/N: KT-U-MOUNT-VC70-R) for is used for replacing a
mounted VC5090 with the VC70.
CAUTION
• Mounting surface must be flat and stiff and it must extend evenly for
the entire length of the mounting bracket surface.
• All four mounting holes must be used.
• All nuts and bolts must be checked periodically and tightened if
required.
• When installing the vehicle computer, care must be taken to ensure
that the mounting bracket footprint is fully supported. Additional plates
may be required to achieve this.
Do not mount the vehicle computer with the mounting bracket
perpendicular to a wall.
Use the following figure U-Mount Installation to mount the VC70.
Drill Holes: 10.1 mm ± 0.1 mm (0.43 ± 0.004 in).
To install the U-mount to the VC70:
Position the friction pads in the friction pad mounting area.
1.
Position the U-mount over the mounting holes.
2.
Place lock and flat washers onto cap screws.
3.
Any modification to supplied mounting bracket could
cause failure of the unit and/or mountings.
160.00 ± 0.20 mm (6.299 ± 0.008 in).
25.40 ± 0.10 mm
1.00 ±0.004 in.
9