Troubleshooting - Hoover uh70608 Owner's Manual

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative,
If appliance iS not working as it should, has been dropped, damaged, left outdoor, or dropped into water, take
it to a service center prior to continuing use.
A, WARNING
To reduce the risk of personal injury - Unplug before cleaning or servicing,
............................................ , ,,,,,,, .....
PROBLEM. POSSIBLE CAUSE POSSIBLE SOLUTION
Vacuum won't
run
System Check
Indicator has
turned red
or
Vacuum won't
pick up
or
Low suction
Cord Rewind
does not work
Dust escaping
from vacuum
Headlight not
working
Vacuum is
difficult to
push or won't
move
forward
Air-Powered
Hand Tool
brushrotl
won't turn
2. Blown fuse or tripped breaker.
1.RinsabLe Filter arl_ or Filter
made with HEPA media is dir_.
3. Broken or worn bel.
5, Carpet height setting is incorrect,
1. Cord reel does not retract.
2, Dirt cup not installed correctly.
4. Rinsable and/or Fitter made with
HEPA media not installed completely,
2, Loose electrical wires,
2. Brushroft is activated.
2. Blockage.
2, Check fuse or breaker in home.
Replace fuse/reset breaker in home.
1. Clean Rinsable Filter and or Filter made
with HEPA media- Pg. 11.
3. Replace belt - Pg,14.
5, Set Carpet Height Adjustment to appropri-
ate setting tot carpet being cleaned - Pg.7.
1. Call 1-800-944-9200 for the nearest
authorized service representative,
2, Review Dirt Cup removal & replacement -
Pg. 11.
4. Review Filter Removal and Cleaning - P9.
11.
2. Ceil 1-800-944-9200 for nearest authorized
Hoover _ dealer,
2. For very high pile carpet deeper than 1",
turn bmshroll off.
2. Remove blockage,
Smoky,/burn _ I. Be_tbroken or stretched. 1. Replace brushroll belt- Pg. 14.
ing smell
detected .............................
15