Trouble Shooting; Troubleshooting - Bosch sensixx'x DI90 Operating Instructions Manual

Trouble shooting

Problem
The iron does not
heat up.
"SensorSteam"
indicator lamp (3)
flashes.
The lights inside
the temperature
control (15) flash.
The clothes tend to
stick.
Water drips out of
the soleplate
together with
steam.
Steam does not
come out in
horizontal position.
Excessive dripping
or steaming.
The pump does not
work.
Smoke comes out
when connecting
the iron for the first
time.
Deposits come out
through the holes
in the soleplate.
The appliance
makes a pumping
sound.
If none of the above solves the problem, get in touch with an authorised technical service.
Probable cause
1. Temperature control (15) set
to minimum.
2. The "SensorSteam" system
has been activated. The iron is
set to stand-by.
1. The "SensorSteam" system
has been activated. The iron is
set to stand-by.
1. The soleplate is heating up or
cooling down to the selected
temperature.
1. The temperature is too high.
1. Temperature control (15)
setting is too low.
2. You have pressed the shot of
steam button (7) repeatedly
without waiting for 5 seconds
between each press.
1. Steam control is set to " "
position.
2. The temperature is too low.
Anti-drip system is activated.
1. No proper closing of
"Calc'nClean" system.
1. The iron is not in a horizontal
position.
1. This may be caused by the
lubrication of some of the
internal parts.
1. Traces of lime scale are
coming out of the steam
chamber.
1. Water is being pumped into
the steam chamber.
Solution
1. Turn to a higher position.
2. Grip the handle (1) of the iron
to re-start it.
1. Grip the handle (1) of the iron
to re-start it.
1. This is normal and lights will
stop flashing when the
selected temperature is
reached.
1. Turn the temperature control
(15) down and wait until the
iron has cooled down.
1. Turn the temperature control
(15) to a higher setting and
wait until the "TempOK" lights
inside the temperature control
stop flashing and remain lit
continuously.
2. Wait 5 seconds between each
press of the shot of steam
button.
1. Set the steam control to "eco"
or "max" position.
2. Set to a higher temperature if
compatible with the fabric.
1. Actuate a few times the
"Calc'nClean" button (16).
1. Use the iron in a horizontal
position.
1. This is normal and will stop
after a few minutes.
1. Carry out a cleaning cycle
(see "Calc'nClean" section).
1. This is normal.
19
BOS CH