Grid-Eye Sensor - Panasonic Grid-EYE User Manual

WARNING

The jumper shunt for the pin-header designated J18 must not be placed on the
pin-header prior to using the board, unless the intent is to access the
Bootloader.

The Grid-EYE board has Arduino headers soldered on for convenience, should
the user choose to host the board onto an Arduino (DUE) mother board. Users
are reminded to be careful so not short-out the pins or have the board resting
on a conductive surface.

2.2.1 Grid-EYE Sensor

Specification
Power voltage
Current consumption
View angle
Absolute temperature accuracy
Noise Equivalent Temperature
Difference
Frame rate (selectable):
External interface
Operation mode
Number of Pixel
Grid-EYE Sensor options:
Whilst the Evaluation Kit hosts and demonstrates capabilities of the 3.3V, Low Gain device,
the user has the following options available for design-in and application:

3.3V high gain

3.3V low gain

5V high gain

5V low gain
User Manual
Value
3.3V ±10%, 5V ±10%/
4.5mA (normal), 0.8mA (standby), 0.2mA (sleep)
60 degrees (x,y)
o
High gain: ±2.5 C (typ.)
Low gain: ±3.0ºC (typ.)
0.5°C @ 10Hz
1 frame/sec or 10 frames/sec
2
I C (12bit)
Normal, Standby, Sleep (Selectable)
64 - (Vertical 8 × Horizontal 8 Matrix)
Grid-EYE Evaluation Kit
6