Blurex Wireless-N Quick Start Manual

Hide thumbs

Table Of Contents

Wireless-

Repeater

Table of Contents

Need help?

Do you have a question about the Wireless-N and is the answer not in the manual?

Questions and answers

Summary of Contents for Blurex Wireless-N

Page 1 Wireless- Repeater...
Page 2 RJ45 Port LAN Indicator Reset NOTE: if you need to reset the Blurex Wi-Fi repeater you need to press and hold the reset button inside the tiny hole for 10 seconds NEED HELP SETTING UP YOUR BLUREX REPEATER CALL 877.300.7156...
Page 3 Package Contents Before you use this router, please check if there is anything missing in the package, and contact Blurex to Claim for missing items 1 x Wireless-N Repeater 1 x RJ-45 Networking Cable 1 x Quick installation Guide Getting Started...
Page 4 192.168.10.1 into the address bar. The Login Screen will appear as in the picture. Enter the User Name (admin) and password (admin) 4. After logging in, click “Repeater” (located in the top Wizard Menu) select “repeater” and click ‘Next’ Wireless-N Wifi Repeater...
Page 5 NOTE: if you need to reset the Wi-Fi repeater you need to press the reset button inside the tiny hole for 10 seconds, Release & Hold Again for 10 Seconds 8. Repeater placement; Since the Blurex Wi-Fi repeater takes your existing Wi-Fi signal and repeats it further, you want to place the repeater between your router and the dead spot in your home or office.
Page 6 2. Connect the repeater to your PC or laptop using the included LAN cable. 3. Open any web browser and type 192.168.10.1 into the address bar. The Login Screen will appear as in the picture. Enter the User Name (admin) and password (admin) Wireless-N Wifi Repeater...
Page 7 You should see icons for the computer you added and for the other computers and devices that are part of the network. Note: If you don’t see icons in the network folder, then network discovery and filling Wireless-N Wifi Repeater...
Page 8 (SSID) and channel. The access point can be set simply with only the minimum setting items. Factory default and settings backup, restore You can back up all settings to this router to a file, so you can make several copied of router configuration for security reasons. Wireless-N Wifi Repeater...
Page 9 You can also use this firmware upgrade function to add new functions to your router, even fix the bugs of this router. Wireless-N Wifi Repeater...
Page 10 Default Password of the router is “admin”, and its displayed on the login prompt when accessed from the web browser. There’s a security risk if you don’t change the default password, since everyone can see it . This is very important when you have wireless function enabled. Wireless-N Wifi Repeater...
Page 11 4. Go to “Ethernet” on the left panel. 5. Click “advanced” 6. Go to TCP/IP configure IPV4 and choose “manual” instead of “using DHCP”. Input the following into the corresponding boxes IP address = 192.168.10.20 Subnet mask 255.255.255.0 Router = 192.168.10.1 Wireless-N Wifi Repeater...
Page 12 www.blurex.com...