Driveline - Cub Cadet FM48 Operator's Manual

FM48/FM60/FM72
To replace the belt do the following:
1. Remove belt shields. Clean foreign material from the mower deck and belt area.
2. Release spring tensioner to loosen belt.
3. Loosen rear nuts holding central plate (do not remove them).
4. Remove front nuts holding central plate (see fig. 13).
5. Lift the front of the central plate and remove old belt.
6. Replace new belt starting from the right spindle pulley (see fig. 14).
7. Lower central plate.
8. Replace front nuts. Tighten front and rear nuts holding down central plate.
9. Replace spring tensioner.
10. Reinstall the belt shields.
DANGER: Only use the original driveline supplied with this mower, and always
with the safety shielding.
Carefully read and file away the driveline operator's manual supplied by the
manufacturer. The following does not substitute the information found in the
driveline manual.
Fig. 15
M
AINTENANCE

4.06 - Driveline

min. 6"
MAX.
min. 2"
MIN.
25
O ' M
PERATOR S ANUAL
C C Y
UB ADET ANMAR